Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11

    Re: How to form 3/16" plate?

    Cebby,

    You still building this project?

  2. #12
    Administrator Cebby's Avatar
    Join Date
    Aug 2005
    Location
    Pittsburgh, PA
    Posts
    1,300

    Re: How to form 3/16" plate?

    It's still on the project list, but has slipped down in priority a bit...
    My vehicle sites: 1993 Toyota 4Runner & 2000 Jeep Grand Cherokee

    **NEW** - UZswap.com - a site dedictated to sharing tech about swapping Toyota V8's into 4Runners and Trucks

Similar Threads

  1. Looking for an off-the-shelf source for steel keyhole "buttons"
    By Cebby in forum Metalworking Jigs, Fixtures, Assembly/Disassembly Tools
    Replies: 7
    Last Post: 10-24-2011, 04:35 AM
  2. What is the rule of thumb regarding "unions" in black pipe runs (for natural gas)
    By Cebby in forum General Home Renovation and Repair
    Replies: 2
    Last Post: 07-11-2011, 05:04 AM
  3. Couldn't resist - had to make a "Miller Blue" color scheme...
    By Cebby in forum Tips, Tricks and Forum Announcements
    Replies: 1
    Last Post: 06-10-2006, 09:05 PM
  4. Changed a setting...easier view via "Toolandfab.com forums available"
    By Cebby in forum Tips, Tricks and Forum Announcements
    Replies: 0
    Last Post: 12-14-2005, 11:05 PM
  5. Form fields are yellow on registration page and I can't see what I'm typing.....
    By Cebby in forum Tips, Tricks and Forum Announcements
    Replies: 0
    Last Post: 11-01-2005, 01:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •